Using the CD player
e s player works in much the same way as other players with a few minor differences and special features as explained on this page
oad s label side up shiny side down in the pen and close the player door by hand by lifting the door tab marked PULL
e display shows OPEN when the door is opened CLOSE when it is closed and TOC READ when a s able of on tents is being scanned by the unit after being loaded
NOTE
The
RW discs may be unplayable on the
Playback
ress the playpause Á/π key to start playback and to pause playback
ress the stop key ª to stop play back
Display
se the DISPLAY/ESC key to change the display between track elapsed time track remaining time and total remaining time you cannot do this in menu mode
Skipping between tracks
se the two skipsearch keys marked as Ô? and ¯?, to move back and forward a track at a time by pressing and releasing the appropriate key
Searching within tracks
se the skipsearch keys to search within the disc by pressing and hold ing the appropriate key
The CUE key
e CUE key is a special feature of the hen you press this key the playback position returns to the last point where playback started
hat happens next depends on the CUE menu item setting in the MENU
menuf this is set to CUE playback is paused at the cue point but if it is set to FLS playback restarts from the cue point FLASH is shown on the display
Looping (track)
sing the PLAY menu item set SGL sin gle play ress the LOOP key so that you see LOOP 1 on the display bottom left e current track will repeat
Looping (disc)
sing the PLAY menu item set ALL play all the disc ress the LOOP key so that you see LOOP alone on the display bottom left e whole disc will repeat
Looping (I/O points)
se the I/O key to set the start in point of the loop then use the key to set the end out point e section be tween the points will repeat seamlessly
ressing the I/O key again clears the loop points and cancels loop mode
10 — TASCAM