Pan & EQ
When the EQ/PAN LED is illuminated:
·The lowest of the four encoders shown at right will control the Pan parameter of the SELected channel in Sonar.
·The encoders labeled as GAIN, FREQuency and Q will control those parameters of the EQ band selected by the illuminated buttons on the SELected channel in Sonar. Bands 14 of Sonar’s Channel EQ is supported.
·The first time an EQ Band key is pressed, it selects the appropriate lower band, pressing the same button again selects a higher band. In this way, up to eight bands can be controlled. (Note: The Sonar Channel Strip EQ does not support external control of more than four bands.)
·Holding SHIFT while pressing an EQ band key will enable/disable that EQ band.
·Holding the SET key while pressing an EQ band key will toggle through the available EQ curve types.
Sonar can come with up to three types of EQ,
depending on the version you have. The FW1802 can be set to control any of the three:
·Hold the EQ/PAN key while pressing one of the top three EQ band buttons to select an EQ:
o EQ HI = Channel Strip Sonitus o EQ HI MID = Plugin Sonitus o EQ LO MID = Plugin FX EQ
Aux
When AUX 14 or AUX 58 is illuminated:
·The four encoders control the level of Aux Sends 1 – 4 or Aux Sends 5 – 8 of the SELected channel in Sonar.
·Holding SHIFT while turning and encoder will adjust that Aux Send Pan.
·The four keys toggle Aux Send 1 – 4 enable/disable or Aux Send 1 – 5 enable/disable of the SELected channel in Sonar.
·Holding SHIFT while pressing one of the four keys toggles the Pre/Ppost state for that Aux Send of the SELected channel in Sonar.
