Preparing the remote control

Installing the batteries

1.Open the cover on the back.

2.Paying attention to the +/– orientation, insert two AAA batteries.

3.Close the cover.

When to change the batteries

If the distance that operation is effective becomes shorter or pressing the keys does not have any effect, replace both batteries with new ones at the same time.

Cautions about the use of batteries

Misuse of a battery could cause it to leak, rupture or otherwise be damaged. Please read the precautions on the batteries and on page 4 of this manual.

Cautions about the use of the remote control

•• When using other equipment that can be controlled by infrared signals, the remote control for this unit could operate them accidentally.

•• Use the remote control within the following range.

3 − Preparations

Remote sensor

15° 15°

Operation distance

Directly in front: Within 7 meters

15° left or right: Within 7 meters

Setting remote control operation

When using more than one of these units at the same time, in order to prevent misoperation when using a remote control, you can use a menu setting to prevent a unit from responding to the remote control, with the exception of some keys.

1.Press the MENU key on the main unit or on the remote control.

2.Use the MULTI JOG dial on the main unit or the +/– keys on the remote control to select “IR REMOTE?”

3.Press the MULTI JOG dial on the main unit or the ENTER key on the remote control.

4.Use the MULTI JOG dial on the main unit or the +/– keys on the remote control to select “Disable.”

5.Press the MULTI JOG dial on the main unit or the ENTER key on the remote control.

NOTE

•• The MENU, –, +, ENTER and ESC/CLR keys on the remote control always function.

•• If you select “Enable” in step 4 of the above proce- dures, you will be able to operate the main unit by the remote control again.

TASCAM MD-02/MD-02B 15