Wide SCSI Cards and Kingston Frames
The MMR/MMP are normally shipped with a narrow Symbios SCSI card. The MMR/MMP units also support the Symbios SYM8751SP Wide SCSI card. To install a wide SCSI card, use a grounding strap and follow the installation instructions below:
Removing the Narrow Host Adapter (Symbios SYM 8600SP)
1)Disconnect the
2)Disconnect the
3)Remove the Phillips head screw that secures the host adapter to the chassis.
4)Carefully remove the host adapter.
Installing the Wide Host Adapter (Symbios SYM8751SP)
1)Prior to inserting the wide host adapter into the PCI slot, connect the
2)Insert the wide host adapter into the same PCI slot that previously contained the narrow adapter.
3)Secure the wide host adapter to the chassis with the Phillips head screw.
4)Reconnect the
Wide Kingston Drive Frames
The Kingston SCSI drive frame in the MMR is normally configured for narrow SCSI. TASCAM can also provide MMR/MMP units configured with wide Kingston frames and carriers, and can perform a service upgrade to remove the existing narrow Kinston frame and carrier and replace it with a wide Kingston frame and carrier. Contact your TASCAM representative for pricing and availability on these wide units. Note that a narrow drive carrier will not fit into a wide frame, and vice versa.
It is possible to mount a narrow SCSI drive in a wide Kingston carrier (or vice versa) by means of an adapter inside the carrier. A good source for these adapters and other SCSI cable peripherals can be found at:
CS Electronics
17500 Gillette Ave.
Irvine, California 92614
Tel (949)
CS Model #
CS Model #
SCSI Tips for MMR/MMP Users | 5 | rev 1.0 | 1/26/99 |