Tascam MX-2424 manual Front Bay

Front Bay

7

5

4

2

4

5

2

7

2 7

1 8

3 5

1	Turn off the power and unplug the MX-2424.	! 6 Be sure to set the SCSI ID of the new option device according to the
	Remove the eight screws from the top cover and put them in a safe place.	instructions provided with that device. The internal drive is preset to
		SCSI ID 0. Termination mus t be disabled on the new option device
2	Remove the cables attached to any installed drives.	since the SCSI bus on the MX-2424 is already terminated. If installing
		a DVD-RAM or tape drive connect the supplied 68-50 pin adapter.

3Remove the four screws from the bottom of the unit that hold the drive

	bracket in place. Lift the drive bracket out.	7	Attach the power cables to the original drive and the new option device.
4	Unscrew and remove the front panel blank and save it.		Attach the SCSI cable to the original drive and the new option device.
			The SCSI cable is labelled "FIXED DISK" (this attaches to the internal
5	Install the new option device into the drive bracket and replace the screws.		hard disk) and "BAY DISK" (this attaches to the new option device).
	Re-install the drive bracket into the MX-2424 and replace the screws on the		This cable already has a terminator attached that should not be removed.
	bottom of the unit.	8	Reinstall the top cover and screws.