Taurus Group Adria 1800 inox Steam blast, Vertical steaming, Cleaning, Self-cleaning function

adequate temperature is selected.

Spray:

-The spray can be used in both steam and dry ironing.

-Press the spray button to use this operation.

-The spray button has to be pressed repeatedly to release the first spray.

Steam blast:

-This function proportions extra steam for eliminating wrinkles.

-Press the steam blast button. Wait a few seconds until vapour penetrates the fibres of the garment before pushing the button again. For optimum steam quality, do not apply more than three successive blasts.

-The steam blast button has to be pressed repeatedly to release the first shot.

Vertical steaming:

It is possible to iron hanging curtains, items of clothing on his hanger, etc. To do so, follow the instructions:

-Select the maximum temperature of the iron, while turning the temperature regulator of the iron in a clockwise direction.

-Move the iron in a top to bottom direction while pressing the steam control. Important: for cotton and linen, its recommended to put the iron base in contact with the material. For other more delicated fibres, it’s recommended to keep the iron base at some centimetres of distance.

Once you have finished using the appliance:

-Select the minimum position (MIN) using the thermostat control.

- Remove the water from the water tank.

Cleaning

-Disconnect the appliance from the mains and allow it to cool before undertaking any cleaning task.

-Clean the electrical equipment and the mains connection with a damp cloth and dry.

DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.

-Do not use solvents, or products with an acid or base pH such as bleach, or abrasive products, for cleaning the appliance.

-Never submerge the appliance in water

or any other liquid or place it under running water.

-If the appliance is not in good condition of cleanliness, its surface may degrade and inexorably affect the duration of the appliance’s useful life and could become unsafe to use.

Self-cleaning function:

-It is important to self-clean the appliance at least once a month to remove calcium and any other built-up minerals inside the iron.

-Fill the depository to its maximum level, as indicated on “water fill” section

-Place the iron in the vertical position, plug into the mains and select the maximum temperature.

-Leave the appliance to heat up until the pilot light indicates that it has reached its consigned temperature.

-Press the self-clean button, and keep it pressed down.

-Let the water flow out through the steam