20 Models 358 & 359Operating Procedures
Step 5
Return to the freezer with a small amount of
cleaning solution. With the black bristle brush, brus h
clean the rear shell bearing(s) at the back of the
freezing cylinder(s).
Figure 32
Step 6
Remove the drive shaft drip pan(s) from the fr ont
panel and take to the sink for cleaning.
Note: If the drive shaft drip pan is filled with an
excessive amount of mix, refer to the
Troubleshooting Guide.
Step 7
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Take particular care to brush c lean
the draw valve core in the freezer door. Place all the
cleaned parts on a clean dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.