23
Model C706 Operating Procedures
050126
Step 8
When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, pull thedraw handle down. Draw off all of
the sanitizing solution.
Figure 38
Step 9
Once the sanitizer stops flowing from the door spout,
raise the draw handle. Press the WASH and PUMP
keys, cancelling the beater motor and pump operat ion.
Figure 39
Note: Be su re your hands are clean and sanit ized
before continuing theseinstructions.
Step 10
Lubricate the mix feed tube o- rings located on the end
of the tube with the small hole on the side. Stand the
mixf eed tube in the corner of the m ix hopper. Place the
locking clip in position on the outlet fit ting of the pump.
Figure 40
Priming
Step 1
Place an empty pail beneath the door spout and lower
the draw handle. Be sure the prime plug is still in the
UP position. Pour two gallons (7.6 liters) of fresh mix
into the hopper and allow it to flow into the freezing
cylinder. This will force out any remaining sanitizing
solution. When full strength mix is f lowing from the
door spout, raise the draw handle.
Note: Use only FRESH mix when priming the
freezer.