Troubleshooting

If you experience a problem with the unit, please refer to the following troubleshooting advice before seeking repair.. If you still have a problem, contact the retailer where you purchased the unit or TEAC customer service (on the back cover)..

The following explanations refer to an iPod, but they also apply to use with an iPhone or iPad..

General

 

No power

Check that the power cord is properly connected

 

 

 

to the power source.. If the source is switched, make

 

 

 

 

 

 

sure that the switch is turned on..

 

 

 

Confirm that power is supplied to the outlet by

 

 

 

plugging in another electric device..

 

 

 

 

 

 

Power indicator

If nothing is connected to this unit when the power

 

 

does not light

is turned on, it will enter standby mode, and the ring

 

 

when power

around the button will not light blue.. When you

 

 

button pushed

connect an iPod to the dock connector or connect

an operating computer to the unit using a USB cable,the ring around the button (power indicator) will light blue..

iPod not recognized

Confirm that the iPod model can be used with this unit.. (See page 9..)

If you are using an iPod case, remove it so that the iPod can dock securely..

iPod music cannot

If PC SYNC is set to ON, the iPod cannot be used for

be played back

playback..

 

Set the PC SYNC switch to OFF.. (See page 15..)

The iPod does not recharge

When connected to a computer that does not support recharging of an iPod, the connected iPod will not be recharged if the PC SYNC USB switch is set to ON.. In this case, set the PC SYNC USB switch to OFF to recharge the connected device..

No video output

Press the VIDEO button on the remote control.. (See

 

page 14..)

 

If the iPod has a TV Out menu item, set it to On or

 

Ask..

 

 

Noise appears on

Check that the iPod TV signal setting is NTSC or PAL

TV screen

as appropriate.. (See page 14..)

 

 

Since this unit uses a microcontroller, external noise and other interference can cause the unit to malfunction.. If this occurs, unplug the power cord, wait for a while, then restore power to the unit and try using it again..

16