Teac CD-W58 E specifications Rear Panel, Configuring the CD-RWDrive

Rear Panel

Rear Panel

							power
	analog	audio
						interface
				CSEL/Slave/Master
S1
									frame
	connector		configuration jumper		connector		connector	ground

S1: Reserved for factory use only.

analog audio output connector: You can use an audio cable to connect this connector to the audio input connector on a sound card. Pin assignments are described below:

Pin Number	Audio Signal
1	Left signal
2	Ground
3	Ground
4	Right signal

CSEL/Slave/Master configuration jumper: The CD-RW Drive includes three pairs of jumper pins on the rear panel that allow you to set the drive to CSEL, Slave, or Master mode.

interface connector: Use an IDE interface ribbon cable to connect the CD-RW drive to an IDE interface in your computer.

power connector: Connect the power connector to the +5VDC and +12VDC power sources. The +5VDC terminal is on the left as you face the rear panel; the +12VDC terminal is on the right. The two center terminals are ground terminals.

FG: Frame ground. This is a ground connection for the CD-RW Drive.

Configuring the CD-RW Drive

The Master/Slave/CSEL jumper configuration of your TEAC CD-RW drive will depend on whether or not you have an IDE CD-ROM/DVD drive installed in your system. The following section will guide you through most typical system configurations.

jumper	jumper	jumper
set to CSEL	set to Slave	set to Master (default)

TEAC CD-RW Installation Guide 3