CSubwoofer
Connect the TO SUBWOOFER and the FROM MAIN sockets using the supplied cable.
Make sure to align the 5 mark on the connector with the 5 mark of the TO SUBWOOFER socket.
DSPEAKERS
Connect the left speaker’s plug to L, and the right speaker’s plug to R.
<If not using the included speakers, make sure the speakers you use are at least 4 Ω impedance.
<Do not connect anything other than speakers to these terminals.
EAC Power Cord
Be sure to connect the power cord to an AC outlet which supplies the correct voltage.
Hold the power plug when plugging or unplugging the power cord. Never pull or yank on the power cord.
FPOWER switch of the Subwoofer
Use this switch to turn the system on or off.
The equipment draws a nominal amount of power from the AC outlet even with its POWER switch in the OFF position.
<If the power switch of the subwoofer turned off, the settings kept in memory (clock, preset stations, timer setting) will be erased.
To avoid loosing your settings, it is advisable to keep this switch ON when not in use.
GAUX IN
You can connect a portable audio player to this jack. Connect the LINE OUT or PHONES jack (audio output jack) of the player using the supplied stereo mini plug cable.
When using the PHONES jack of your mini player, you must adjust the volume of the
Wall Mounting
You can mount the main unit and/or the left and right speakers on a wall.
Precautions
<Be aware that the length of the cables are approximately 3 m. Do not attempt to mount the main unit and the speakers too far from the subwoofer.
<Drill holes into solid wall support, such as wooden frame or concrete wall.
<TEAC supplies these brackets as a convenience to the product owner. Consult your local building codes and exercise all necessary caution when mounting these brackets. If you are unsure how to use the supplied brackets, consult with a local tradesmen or building supply expert.
To hook on the wall
1Use the supplied template to determine drilling points.
2Secure the brackets on the wall using the supplied screws.
<As a convenience, a set of tapered plastic anchors is supplied. If you chose to use these anchors, drill a pilot hole using a 6mm drill bit then tap the anchor into the pilot hole.
Only use these anchors if they are appropriate for the materials onto which the unit is to be mounted. Consult your local hardware store if you are uncertain.
Note:
Before going on, make connections between the main unit and the speakers by referring to page 6.
3Hang the main unit and/or the speakers to the mounting tabs.
Main Unit | Speaker |
3
3
2 | 2 |
7
