Teac X-03SE Repeat mode, Analog output 2CH/MULTI, Track repeat, Disc repeat, Programmed repeat

Repeat mode

Use the REPEAT button to select the repeat mode for playback. Repeated presses of the REPEAT button cycle between the following options:

REPEAT TRK	REPEAT DSC
(track repeat)	(whole disc repeat)

REPEAT OFF (no repeat)

<Halting playback stops the repeat mode.

<The following buttons cancel repeat mode:

STOP, OPEN/CLOSE, POWER.

Track repeat

When this is selected, the currently-selected track repeats. If another track is selected during repeat playback, the newly- selected track repeats.

Disc repeat

The whole contents of the disc are repeated.

Programmed repeat

If programmed playback has been set up, the whole program is repeated.

Pushing the REPEAT button cycles between REPEAT PGM (program repeat) and REPEAT OFF (programmed playback takes place).

Analog output (2CH/MULTI)

When playback is stopped, use the 2CH/MULTI button to select either 2CH (stereo) or MULTI (multi-channel surround) audio output.

2CH

The unit outputs 2-channel stereo sound from the the i.LINK (AUDIO) and the AUDIO OUT terminals.

If multi-channel program material is played, the multi-channel material will be downmixed to two channels and the DOWNMIX indicator will light on the display.

MULTI

The unit outputs the multi-channel surround sound.

Select this when the i.LINK (AUDIO) terminal is connected to a surround sound amplifier.

5.1 indicator will light on the display.

<Note that if “MULTI” is selected, only the front L/R sound of the multi-channel material will be output from the analog AUDIO OUT terminals.

<This setting is also reflected on the setup menu.

<This setting has no effect on the DIGITAL OUT terminals.

15