Techko S082X, S082K manual Operation

TEMPLATE

MODE S082KA

SCREW HOLE

SCREW HOLE SCREW HOLE

TESTING

ALARM OUTPUT AND PANIC BUTTON TEST

To test the alarm output, press the PANIC button located on front of the unit. (THIS UNIT IS VERY LOUD, COVER THE SIREN ON THE FRONT OF THE UNIT BEFORE ACTIVATING). The unit will immediately sound a piercing alarm siren. To disarm the unit, enter your security code followed by the

#ON/OFF	button. (If you have not entered a security code
the default is	0 and S082K is	5
CHIME TESTING
1.Set the function switch to the		CHIME	position.
2.Enter the security code followed by the			#ON/OFF button,

the ALARM LED will illuminate. If this does not happen repeat steps 1 and 2.

3.Close the door and then open it again, a pleasant chime will sound 3 times.

4.To disarm the unit, enter the security code followed by the #ON/OFF button.

5.As long as the unit is in the ARM mode, the chime will

continue to sound until DISARMED .
ALARM TESTING
1.Set the function switch to the INSTANT	or DELAY
position.
2. Enter the security code followed by the	#ON/OFF button,

the ARM LED will turn on. If this does not happen, repeat steps 1 and 2.

3. Close the door and open it again in INSTANT mode, the alarm sounds immediately. If the alarm is in DELAY mode, the alarm will emit a low beep tone to alert your to disarm the unit, if not disarmed, the unit will then sound a piercing alarm.

4.To disarm the unit, enter the security code followed by the #ON/OFF button.

Note: in both modes, CHIME or ALARM (instant / delay) the unit will continue to sound until DISARMED . The unit will only sound the ALARM if ARMED in the ALARM mode. If armed in the CHIME mode the unit will sound only the CHIME. If function switch is changed after the unit has been activated, this will not alter the sound being produced.

OPERATION

ALARM MODE

1.Before arming the unit slide the function switch to the INSTANT/DELAY position.

2.To arm the S082X / S082K, enter the security code followed by the #ON/OFF button, the ARM LED will turn on. If this does not happen repeat steps 1 and 2.

3.INSTANT mode.

When an entry is detected. The alarm sounds immediately. This is used to protect you when you are at home.

4.DELAY mode.

This mode is used when you are leaving your home. On your return, an entry alert beep tone will sound to alert you to disarm the unit. If the unit is not disarmed within10 seconds of entry, the alarm will sound a110db (S082KA is 115db) alarm siren.

5.The 110db/115db alarm will sound for about 30/36 seconds, while the alarm is sounding or during the entry alert time the security code can be entered to disarm the unit.

6.To disarm the unit, enter the security code followed by the #ON/OFF button.

C H I M E M O D E

1 . B e f o r e a c t i v a t i n g t h e c h i m e , s l i d e t h e f u n c t i o n s w i t c h t o t h e C H I M E p o s i t i o n .

2 . E n t e r t h e s e c u r i t y c o d e f o l l o w e d b y t h e # O N / O F F b u t t o n .

3 . T h e A R M L E D w i l l i l l u m i n a t e t o v e r i f y t h e u n i t i s O N , f o l l o w e d b y a s h o r t b e e p . I f t h e A R M l i g h t d o e s n o t

i l l u m i n a t e t h i s i n d i c a t e d t h e u n i t i s O F F.

4 . T h e c h i m e w i l l s o u n d i f t h e r e i s a n e n t r y. T h e c h i m e w i l l

s o u n d f o r e a c h e n t r y u n t i l t h e u n i t i s t u r n e d O F F ( d i s a r m e d ) N O T E : T h e p o s i t i o n o f t h e f u n c t i o n s w i t c h d o e s n o t

n e c e s s a r i l y i n d i c a t e t h e m o d e t h e u n i t i s i n

( C H I M E / I N S TA N T / D E L AY ) . E a c h t i m e b e f o r e

a c t i v a t i n g t h e u n i t , s e t t h e f u n c t i o n s w i t c h t o t h e c o r r e c t p o s i t i o n f o r t h e m o d e d e s i r e d .

PANIC ALARM

The red PANIC button on the front panel activates the alarm during a possible emergency.

1 . Press the panic button . This will activate the 110db (S082KA is 115db) alarm siren .

2 . Disarm the PANIC alarm, follow the same procedure as you would to DISARM the unit .

CAUTION

THE MAGNET GUARD IS EXTREMELY LOUD. FOR YOUR SAFETY. NEVER PLACE THE UNIT CLOSE TO YOUR EARS. TO TEST THE ALARM, DIRECT THE UNIT AWAY FROM YOU AT ARMS LENGTH AND ACTIVATE.

PATENT PENDING NOTICE

THIS PRODUCT IS PROTECTED UNDER FEDERAL PATENT. TRADEMARK AND COPYRIGHT LAWS AND LAWS PREVENTING UNFAIR COMPETITION. NO DUPLICATION OR SIMULATION OF THIS PRODUCT IS PERMITTED EXCEPT BY WRITTEN AUTHORIZATION OF TECHKO, INC. TECHKO AND THE CONFIGURATION OF THIS PRODUCT ARE TRADEMARKS OF TECHKO, INC. COPYRIGHT 1992 TECHKO, INC. ALL RIGHTS RESERVED

Customer Service :

1-888-8TECHKO (1-888-883-2456)

Website: www.techkomaid.com

Mfg. By

9767 Research Drive

Irvine, CA 92618-4626

MADE IN CHINA

SAFETY SECURITY

MAGNET GUARD

MODEL S082X/S082K

S082KA

1 2 3

4 5

* #

PANIC

S082K

S082X

1 2 3

4 5 6

7 8 9

* 0 #

S082X

OPERATION MANUL