Technicolor - Thomson DPL909VD Connections, Connecting to AM / FM antenna, Connecting to Speakers

RIGHT

- +

LEFT

- +

Connections

CENTER	EN
- +

Red Black White Black

+

-

FR	FL	C	SR SL	SW
	8 ohm			6 ohm
	Black	Grey	Black	Blue
	REAR			REAR
	-	+		- +

Black Green

Purple

Black

- +

Connecting to AM / FM antenna

•Connect the supplied AM loop antenna to the AM jack. Position the loop antenna to receive the clearest sound.

•Connect the supplied FM antenna to the FM jack. Move the antenna in various direction until the clearest signal is received.

Note

•Keep the antenna as far away as possible from the TV, VCR or any radiation source to prevent unwanted noise.

If you have poor FM reception

For better FM reception, use a 75 ohm coaxial cable (not supplied) to connect the system to an outdoor FM antenna as shown.

AM

Connecting to Speakers

Connect the supplied speakers ,using the supplied speaker wires to match the colors of the jacks and speaker wires.

•Connect the supplied speaker wire its corresponding terminal jacks.

To avoid short-circuiting the speakers

•Short-circuiting of the speakers may damage the system. To prevent this, make sure to take the following precau- tions when connecting the speakers.

•Make sure the stripped end of each speaker cord does not touch another speaker terminal or the stripped end of another speaker cord.

Note

•Be sure to match the speaker cord correctly.

•For optimal sound performance, use the supplied speakers.

•Do not connect speakers with an impendence lower than the speakers supplied.

Examples of poor conditions of the speaker cord

•Stripped speaker cord is touching another speaker terminal.

•Stripped cords are touching each other due to exces- sive removal of insulation.

FM 75 Ω

7