Technicolor - Thomson DTH231 Connecting DVD player + TV set + VCR, Other Audio Video connections

2_DTH231_EN 21/08/03 15:50 Page 3

Connections and initial set up

The rear panel of your television set and your video player may be different from the ones illustrated here.

		1
	Television set
	4
3	Video recorder	DTH 231
		2

5

EN

Connecting: DVD player + TV set + VCR

If you are only connecting your player to your television set, only carry out the connections shown in stages 1 and 5. If no Scart-Peritel socket is available on the TV set consult your retailer. If you already have a VCR the connections shown in stages 3 and 4 should, in most cases, already be in place.

Recommended Audio – Video connection

1.Plug the Scart-Peritel cable provided into the your DVD player and into the AV1 in socket your TV set

TV AUDIO VIDEO out socket at the back of (sometimes also called AUX 1 or EXT 1) on

2.Plug your VCR Scart-Peritel cable into the VCR/SAT/AUX socket on your DVD player and into the TV socket on your VCR.

Other Audio - Video connections

If no Scart-Peritel socket is available on the TV set, check whether the set has another Video socket (Components, S-Video or Composite) that you can use to connect to your player using the corresponding socket. In this case do not forget to also connect the Audio out socket (AUDIO OUT) to the Audio in socket (AUDIO IN) on your TV set.

Note: if your TV set is equipped with Component sockets and you opt for this connection, you must set the RGB/YPRPB selector on YPRPB (see page 5). For more information about signals, cables and Audio/Video sockets refer to pages 4 and 5.

3.Plug the outside aerial or the network into the aerial in socket (IN ) on the VCR.

4.Use a coaxial cable to connect the aerial out socket on the VCR (OUT ) and the aerial in socket ( ) on your TV set.

5.Plug the mains plug of your player into a mains socket.

Continue on page 6

3