Technicolor - Thomson ITC250S Other information, Connecting headphones, Connecting an amplifier

SUB-WFR

Other information

Audio CINCH sockets (output) inside the front panel

L These can be used to connect a stereo amplifier, a hi-fi system or amplified speakers (see

below).

R

	AV3 audio and video CINCH sockets (input) at the front
	or side
	These can be mainly used to connect camcorders (VHS or 8 mm format).
L. R. VIDEO S	S socket and AV3 audio CINCH sockets (input) at the
		EN
AUDIO	front or side
	These can be mainly used to connect camcorders (S-VHS or Hi 8 format).
	To display images using the equipment connected, press the AV button on the remote
	control: once to select AV1, twice to select AV2 and three times to select AV3. For some
	equipment (connected to the SCART sockets), this selection is done automatically.

SW

Connecting headphones

Use the relevant socket on the front of the TV set to connect headphones or stereo earphones. Refer to page 12 on how to adjust the headphone volume.

Connecting active speakers

The audio CINCH sockets inside the front panel of the television can be used to connect active speakers (with a built-in amplifier) replacing the television’s built-in speakers.

Left and right speakers: connect the left speaker to the CINCH L socket and the right speaker to the CINCH R socket.

Subwoofer: connect the subwoofer to the SUB-WFR socket.

Connecting an amplifier

You can connect an amplifier and 2 speakers to replace your television’s side speakers: Connect your television’s left L and right R CINCH sockets to the amplifier’s L and R inputs. Configure the set as follows (see page 12):

Sound menu	Set menu
Sound type: Stereo	Left/Right speakers: External
Sound mode: Normal	Subwoofer: None

The television’s side speakers and subwoofer are now disabled. Adjust the volume using the amplifier.

Connecting a video recorder

To obtain optimum picture quality, use a SCART cable. However, you can also connect a video recorder to the television using the aerial socket.

Refer to the diagram on the inside cover at the end of the manual, which illustrates how this is done.

If you connect a video recorder only via the aerial socket (without using the SCART socket), switch it on and play a tape.

Then use the Auto-updateoption of the Installation menu to search for the video recorder signal (refer to the Manual set-up section).

If you connect a video recorder via the aerial socket, you should assign channel 99 to it in order to improve the picture quality when tapes are being played and in pause mode. However, we recommend you connect your video recorder via the SCART socket, as it provides better picture and sound quality.

25