Assembly |
|
|
Viewfinder Mount |
| |
Retaining Knob |
| |
Support | Lens | 70 VA max |
rail slot | Locking |
|
| Handle |
|
Lens |
|
|
support |
|
|
rail |
|
|
|
| Balance Knob |
|
| Bayonent Ring |
|
| Locking Lever |
It is important that you assemble and disassemble the units in the right order. The correct order of assembly is as follows:
1.Attach the large lens adapter to the tripod.
2.Mount the lens onto the large lens adapter.
3.Attach the camera to the large lens adapter.
4.Mount the
To disassemble the units follow this order in reverse.
Tripod
To mount the large lens adapter on a tripod, first attach the tripod wedge plate to the underside of the adapter as follows:
a.Lie the large lens adapter on its side.
b.Ensure that the flat side of the tripod wedge plate is against the underside of the large lens adapter.
c.Secure the tripod wedge plate to the large lens adapter by screwing four M6 x 16 screws into the holes provided.
d.Slide the large lens adapter onto the tripod and lock in place with the tripod locking bar and security pin.
Mounting a Lens
To mount the lens onto the large lens adapter, proceed as follows:
a.Slide the viewfinder support back towards the rear of the large lens adapter.
b.Hook the lens onto the support rail ensuring that the upper lens pin fits into the slot in the support rail.
c.Swing the lens downwards so that the lower lens pin fits into the hole in the front of the camera.
d.Turn the lens locking handle clockwise to secure the lens in place.
If the lens cannot be secured see Information on the next page
To remove the lens, remove the camera from the large lens adapter first, then follow this procedure in reverse.
02.38.3 | User's Guide LDK 4482 - SuperXpander |
