Technicolor - Thomson TM9049 manual Maintenance

Models: TM9049

1 14
Download 14 pages 30.41 Kb
Page 14
Image 14

Maintenance

Cleaning the exterior

Disconnect the system from AC power before cleaning the exterior of the unit with a soft dust cloth

Clean the exterior with a soft clean cloth or slightly moistened chamois leather. DO NOT use solvents as it may cause damage to the unit.

Handling CDs

• Do not touch the signal surfaces. Hold CDs

by the edges, or by one edge and the hole.

• Do not affix labels or adhesive tapes to the

label surfaces. Do not scratch or damage the

label.

• CDs rotate at high speeds inside the player.

Do not use damaged (cracked or warped)

CDs

• Make sure CDs are stored in their original

case after use. Keep them away from damp,

CD Lens Care

EN

 

 

When your CD lens gets dirty it can also cause the system to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner which can maintain the output sound quality of your system. For instructions on cleaning the CD lens, refer to the ones accompanying the lens cleaner.

Cassettes

To protect your recordings from accidental erasure on one or both sides of your cassette, snap out the tab at the top of the cassette. If you decide later to record on the tape, seal the hole with a piece of adhesive tape. (Refer to diagram)

A

A

A

humid or abnormally heated places.

Cleaning CDs

Dirty CDs can cause poor sound quality. Always keep CDs clean by wiping them gently with a soft cloth from the inner edge toward the outer perimeter.

If a CD becomes dirty, wet a soft cloth in water, wring it out well, wipe the dirt away gently, and then remove any water drops with a dry cloth.

Do not use record cleaning sprays or antistatic agents on CDs. Also, never clean CDs with benzene, thinner, or other volatile solvents which may cause damage to disc surface.

A 60

Quit Slacking - A little bit of slack in your tapes can cause

scratches on the tape, or worse yet, the tape could break. If you notice some slack in the tape, use a pencil to tighten it up before you insert it.

Technical Specification

Power supply: 230V~50Hz Dimensions ( H x W x D mm): Unit size - 152 x 368 x 279

A

CD player: Response curve (+/- 2dB): 60Hz to 20 kHz

Rating Plate: Look for it at the bottom of the set.

11

TM9049 EN

15

1/7/05, 10:19 AM

Page 14
Image 14
Technicolor - Thomson TM9049 manual Maintenance