Technics SA-DX950, SA-DX1050 manual Preparations, Adjusting speaker output level

	1					Adjusting speaker output level
						Adjust the level of the speakers so they are the same apparent level
						as the front speakers when you are sitting where you would
						normally enjoy a source.
						1 Press [A] to turn on SPEAKERS A.
						You cannot adjust output level when SPEAKERS B is on.
						2 Press [TEST] to output the test signal.
						DSP sound mode switches to SURROUND mode.
						The signal is output from each speaker in order for about two
						seconds each:
		DISPLAY		RETURN		L: Front speaker (left)
		/	/		5	C: Center speaker
	4	DELAY	LEVEL –	+		R: Front speaker (right)
		SUBWOOFER	SOUND MODE SFC	TEST	2,6	RS: Surround speaker (right)
		TV/AV	– TV VOL+	MUTING		LS: Surround speaker (left)
		– VOLUME		+	3	SW: Subwoofer
						Speakers set as “NONE” or “NO” are skipped.
						Note
						The test signal will not be output if DSP is defeated (\ page 22)
						or DVD 6CH INPUT is on (\ page 19).
1						3 Adjust the volume to the level
	SPEAKERS					normally used.
	A
						Adjust the balance of the front speakers if necessary
				SPEAKERS		(\ page 20).
				A
						4 Press [LEVEL] to select the speaker
2						channel to adjust.
						The current level appears on the display.
	TEST					Press again to change the speaker channel.
						Speakers set as “NONE” or “NO” are skipped.

Preparations

L C R RS LS SW

3 – VOLUME +

4 LEVEL

5 Press [–] or [+] to adjust the level to the same apparent level as the front speakers.

C, RS, and LS can be adjusted between –10 dB and +10 dB, with zero being the current level of the front speakers.

SW can be set to MIN, between 1 to 19, or MAX.

Repeat steps 4 and 5 for each speaker channel.

6 Press [TEST] to stop the test signal.

For your reference

Subwoofer output is easily influenced by the source played. You can achieve better results by adjusting its output while listening to a source (\ page 21).

5 – +

6

TEST

15

RQT5802