GETTING STARTED

FM AERIAL

Before using your clock radio for FM reception, unwrap and fully extend the aerial wire. You may need to adjust the position of the aerial wire for maximum signal strength.

CONNECTING AC MAINS POWER

Before connecting the power, check that the mains voltage on the rating plate of the AC adaptor is the same as the voltage in your area.

•Plug the DC cord from the AC adaptor into the DC jack on the back of the unit.

•Plug the AC adaptor into the wall socket and switch the mains power on.

The unit is now ready for use.

NOTE:- The AC adaptor may become warm during operation - this is normal.

BATTERY OPERATION

Your radio can also be powered from batteries.

When fitted, batteries will also provide backup to power the clock and alarm in the event of a power cut.

For battery fitting instructions, refer to the section ‘Fitting Batteries’ on the previous page.

Low battery warning

Your radio includes a warning symbol that flashes to indicate when battery level is low. If you are using battery power and the battery warning appears, change the batteries immediately.

Low battery indicator

BATTERY DISPOSAL

Dispose of used batteries with regard to the recycling regulations in your area. Do NOT short circuit batteries or throw them into water, the general rubbish or in a fire.

Weak batteries can leak and damage the unit. Replace them in good time!

POWER CONTROL

STANDBY CONTROL

To turn the radio on:

•Press the POWER/FUNC. button on the top panel. The display will light and the radio will switch on.

To set the radio to Standby:

•Press and hold the POWER/FUNC. button on the top panel.

The radio will set to Standby. The clock will be displayed.

SETTING THE CLOCK

When first switched on, the clock display on your radio will flash ‘zeros’ until the clock has been set. If you find the clock display reverts to this display at any time, it is possible that there has been a power cut and the clock will need re- setting.

To set the clock:

With the radio set to Standby -

•Press and hold the SET button. The hours digit will flash.

•Press the SKIP-/TIME- or SKIP+/TIME+ button to set the correct hour (24 hour clock).

•Press the SET button to confirm this setting.

The minutes digits will flash.

•Press the SKIP-/TIME- or SKIP+/TIME+ button to set the correct minutes.

•Press the SET button to confirm this setting.

The clock is now set.

5