POWER CONTROL

STANDBY CONTROL

To turn the radio on:

•Press the MENU/button on the front panel or the red button on the remote control.

The display will light and the radio will switch on.

To turn the radio off:

•Press and hold the MENU/button on the front panel or press thebutton on the remote control briefly.

The radio will switch off. The clock will continue to run whilst mains power is connected.

INITIAL SCAN

When your radio is switched on for the first time the scanning display will be shown while the scanning process takes place:

Progress bar

Number of stations found

The radio scans all usable stations (full scan) and stores them alphanumerically - 1 Radio, 2 Radio, AA Radio, AB Radio...

The initial scan will take a few minutes. After the scan, the clock will be set and the radio will display the name of the first station in the sequence. To select this station, push the VOLUME/SELECT/ENTER control on the front panel (or the SELECT/ENTER button on the remote control). To browse for another station, refer to the next section.

BROWSING FOR A STATION

To browse for another DAB station from the front panel controls:

•Press the MENU button. <Station list> will be displayed.

•Push the VOLUME/SELECT control to display the station list.•Turn the VOLUME/SELECT control to browse the station list.•Push the VOLUME/SELECT control to select the station displayed.After a short delay, the radio will tune to the station.

To browse for another DAB station from the remote control:

•Press the M or N button repeatedly to browse through the station list.•When you find a station you want to play, press the SELECT/ENTER button.

After a short delay, the radio will tune to the station.

ADJUSTING THE VOLUME

To adjust the volume from the front panel controls:

•Turn the VOLUME/SELECT button to adjust the volume, clockwise to increase and anti-clockwise to decrease.

To adjust the volume from the remote control:

•Press the or button to increase or decrease the volume level.

When the volume is adjusted the display will change to show the current volume setting on a bargraph.

Volume bargraph

MUTE

To mute the sound:

•Press the MUTE button.

The sound will mute and ‘Volume Muted’ will be displayed..

•Press the MUTE button again to restore the sound to its previous volume level..

6