DAB SETTINGS MENU

MORE DETAIL OF THE DAB SETTINGS MENU OPTIONS:

AUTOSCAN: Select Autoscan to re-scan the entire DAB band and refresh the station list.

MANUAL TUNING: Manual tuning enables you to search the band manually by pressing the P or O button to step through the multiplex numbers and check if any have usable signal strength on a bargraph display. Manual tuning is not necessary in normal operation where scanning will have automatically established a station list of all usable stations.

DRC: DRC is Dynamic Range Compression. Enabling DRC may improve the sound of DAB radio when listening in a noisy room.

PRUNE: If your station list includes stations that you can no longer receive (you may have moved to a different area), you can select the ‘Prune’ option to remove any stations that can no longer be received from the Station List.

MORE DETAIL OF THE SYSTEM SUB-MENU OPTIONS: SLEEP: Select this option to set a sleep time in the range 15-90 minutes. When a sleep time is set, the radio will set to Standby after the sleep delay time. Choose ‘Sleep Off’ to cancel sleep mode.

ALARM: Select this option to set alarm times and activate one or both of the dual alarms. There are more details of alarm setting on the following page.

TIME: Select the time option to set the clock manually. This may be useful if you are in an area where it is not possible to receive DAB radio broadcasts. Within the time menu options it is also possible to change the clock display format between 12 and 24 hour, to choose whether the clock should set from the DAB time signal (Auto update) and to change the format of the time and date display.

BACKLIGHT: Select‘Backlight’, then the‘Timeout’sub-option to change the backlight settings. Choose from ON (backlight is permanently on) or a delay time in seconds. If you choose a delay time, the backlight will switch to full brightness when a button is pressed, then change to low brightness once the delay you set has elapsed.

FACTORY RESET: Select the ‘Yes’ sub-option to reset all the settings of your radio to factory original settings. The station list will also be cleared and any stored preset memories will be erased. After a factory reset the radio will re-scan the band and renew the station list.

SW VERSION: This option will display the version number of the control software currently installed in your radio. This will be helpful to a technician who is servicing the radio.

FM SETTINGS MENU

FM SETTINGS MENU

There are also some menu settings that are specific to FM radio operation. These settings may be changed through the Settings Menu.

To enter the FM Settings Menu:

•Set to FM mode.

•Press the MENU button.

A map of the menu is shown below. The menu is navigated in the same way as the DAB settings menu.

SCAN SETTING

AUDIO SETTING

SYSTEM SETTING

MORE DETAIL OF THE FM SETTINGS MENU OPTIONS

SCAN SETTING: With this menu option you can set the scanning sensitivity of the FM radio to two different levels- ‘Strong stations only’ or ‘All stations’. Setting to ‘Strong stations only’ will exclude weaker stations resulting in a quicker scan. If you set to ‘All stations’ the scan will stop at every station detected, even if the signal is weak.

AUDIO SETTINGS: This option enables you to set the radio to receive FM in Auto mode (Mono/Stereo) or in Mono only. This may be useful if the signal is weak and the broadcast is noisy.

SYSTEM: The System sub-menu options are the same as those described in the DAB settings section.

9