GETTING STARTED

REMOVING THE PACKING FROM THE CD PLAYER

Before connecting power to your audio system, the protective packing should removed from the CD compartment.

To remove the protective packing:

•Open the CD compartment by pressing down on the OPEN/CLOSE area marked at the front corner of the CD lid.

The lid will open.•Remove the cardboard protective packing from the CD compartment.•Close the CD lid.
DAB/FM RADIO AERIAL

Before using your radio for DAB or FM reception, unwrap and fully extend the aerial wire. You may need to adjust the position of the aerial wire for maximum signal strength.

CONNECTING POWER

•Check that the mains voltage marked on the rating plate under the unit is the same as the voltage in your area.

•Plug the AC power cord into the AC inlet•Plug the mains plug into the wall socket and switch the mains power on.

SETTING THE CLOCK

Automatic clock setting:
The clock time will set automatically when a DAB station is first tuned.

In areas where DAB reception is not available, manual clock setting will be necessary.

To set the clock manually:
•With the system set to Standby, press and hold the MEMORY/CLOCK button.The display will show the legend ‘24 HOUR’ with the digits 24 flashing.

NOTE: The display will not light during clock setting.

•Press the or buttons to select 24 hour or 12 hour mode for the clock.•Press the MEMORY/CLOCK button.The display will show the time currently set with the hours digits flashing.•Press the or buttons to set the hours digits to the correct time.

•Press the MEMORY/CLOCK button.

The display will show the time currently set with the minutes digits flashing.•Press the or buttons to set the minutes digits to the correct time.

•Press the MEMORY/CLOCK button.

The clock settings will be stored.

STANDBY CONTROL

STANDBY CONTROL
To turn the system on:
•Press the STANDBY button on the front panel or remote control.

The display will light and the system will set to play the last function used. If this was radio, the last station played will be selected.

To turn the system off:
•Press the STANDBYbutton.

The system and display light will switch off. The clock will continue to run whilst mains power is connected.

ADJUSTING THE VOLUME

VOLUME CONTROL
To increase the volume:

•Turn the VOLUME knob clockwise or press the VOLUME + button on the remote control.

To decrease the volume:

•Turn the VOLUME knob anti-clockwise or press the VOLUME - button on the remote control.

MUTE
You can use the Mute function to instantly set the volume to minimum.
To mute the volume:
•Press the MUTE button on the remote control to set mute at any time.•Press the MUTE button again to restore the volume to its previous setting.

7