FITTING BATTERIES

Batteries may be fitted to power your docking station for portable operation and also to provide backup power to retain preset memories when mains power is disconnected.

To fit batteries:

1.Slide the battery cover in the direction shown to unclip the latch. Lift off the battery cover.

2.Fit four ‘AA’/’UM3’ batteries into the battery compartment, observing polarity as shown.

3.Re-fit the battery cover and slide it to lock it into place. NOTE: The battery indicator will flash if there are no batteries fitted or if the battery level is low and needing replacement.

BATTERY CAUTIONS

Remove the batteries if the unit will not be used for a long time to avoid the danger of leakage.

NOTE: Never mix old and new batteries or batteries of different types. Batteries should always be replaced as sets. Dispose of used batteries with regard to the recycling regulations in your area. Do NOT short circuit batteries or throw them into water, the general rubbish or in a fire. Weak batteries can leak and damage the unit. Replace them in good time!

SELECTING A SOURCE

You can choose to play music from a docked iPod, FM radio or a personal audio player or other source connected to the AUX IN jack on the rear panel.

To select a source:

Press the SOURCE button to step through the sources. If iPod is selected, the display will show ‘iPod’.

If FM is selected the display will show the tuned freuqency. If the Aux input is selected, the display will show ‘AU’.

ADJUSTING THE VOLUME

To increase the volume:
Press the button.
To decrease the volume:

Press the button.

When the volume is adjusted, the volume level is displayed briefly on a scale of 0 (minimum) to 20 (maximum).

SOUND EQUALISER

Your docking station includes a sound equaliser with five different preset responses.

To change the sound equaliser setting:
Press the EQ button repeatedly.

The equaliser mode selected will change in the sequence -

In the FLAT setting, no equalisation is applied.

LISTENING TO THE RADIO

If FM mode is not selected, press the SOURCE button to select FM mode.The tuned frequency is shown on the display and the radio will play.
To tune to a station:

Press the ] or [ buttons to tune the radio up or down the band. Pressing these buttons briefly will move the frequency by one step, holding the buttons for longer will start a search which will stop automatically at the next station in the band.

The display will show the tuned frequency in MHz.
FM PRESETS

Your radio can store up to 10 of your favourite stations as presets for quick recall.

To store any preset 1-10

Tune to the station you want to store as a preset.

Press and hold the PRESETS button.The preset display will flash.

Press the ] or [ button repeatedly to find the preset number you want to store.

Press the PRESETS button again to confirm and store the preset.
To browse the station presets 1-10

Press the PRESETS button repeatedly. The preset number playing will be displayed.

NOTE: If batteries are not fitted, any stored presets will be erased if the power is disconnected from the unit.

5