When pulling starter rope, the rope

! WARNING

can unexpectedly jerk back toward

 

engine causing serious injury. To avoid this risk, carefully follow these instructions:

7.Grasp starter cord handle. See Figure 29.

a.Pull rope out slowly until you feel drag.

b.Without allowing the rope to retract, continue pulling rope with one rapid full arm stroke.

c.Return rope slowly to original position.

NOTES

Following the instructions listed in the steps above avoids potential damage to the recoil mechanism.

If recoil starter cord handle is frozen and will not operate engine, proceed as follows:

a.Pull as much rope out of starter as possible.

b.Release starter cord handle and let it snap back against starter to break up ice; these two steps should ONLY be done WHEN starter is FROZEN.

c.If engine fails to start after 3 attempts repeat steps 1 thru 7 and try again.

8.When engine starts:

a.Momentarily move choke control to “1/2 CHOKE” position until engine runs smoothly. See Figure 24 on page 12. Afterward, continue reading instructions below.

b.Next, move choke control to “NO CHOKE” position.

c.Finally, move engine speed control to desired speed in “RUN” range. See Figures 26 and 27 on page 13. Afterward, continue reading instructions below.

NOTES

If engine starts but falters when choke control is moved to “NO CHOKE” position:

a.Momentarily move choke control back to “FULL CHOKE” position.

b.Next, move choke control to “1/2 CHOKE” position until engine runs smoothly.

c.Finally, move choke control to “NO CHOKE” position.

If engine dies after choke control is moved to “NO CHOKE” position repeat steps 3 thru 10 to restart engine.

9.If engine fires but does not continue to run, move choke control to “NO CHOKE” position and start engine. See Figure 24 on page 12. Afterward, continue reading instructions below.

10.If engine fails to start after 3 attempts in the “NO CHOKE” position, move choke control to “FULL CHOKE” position and start engine.

11.If engine does not start after following steps 1 thru 10, contact your Authorized Tecumseh Servicing Dealer. DO NOT attempt to start or troubleshoot this engine in any other way.

Figure 29. Recoil Starter Cord Handle

Page 14

4-Cycle • Snow King Engine

181-1275-14