BATTEUR_PREP-LINE_2544991_8141 N°1 01/12/10 16:46 Page13

3.Connect the appliance.

. Preferably use a deep bowl.

. Immerse the beaters in the preparation before starting to avoid splattering.

. Start up using the speed control (B) (fig.2), first on speed 1 then 2,3,4,5 as the preparation thickens. Use the “Turbo” position (E) if the recipe requires more power.

. Stop the appliance before removing the beaters from the preparation (this will avoid splattering).

Blender function

1. Check that the speed control (B) is in the “0” position.

2. Raise the door located at the back of the appliance and screw in the mixer shaft (F) anti-clockwise without forcing until the red points are aligned (you will hear a light “click” as you go through the red point to tell you that the shaft is correctly screwed in) (fig3).

3. Connect the appliance

. Preferably use a deep bowl.

.Immerse the blender shaft in the preparation before starting up to avoid splashing.

.Start up using the speed control (B) (fig.2), first on speed 1 then 2,3,4,5. Use the “Turbo” position (E) if the recipe requires more power.

.Stop the appliance before removing the blender shaft from the preparation (to avoid splattering).

If you feel resistance when screwing in, this means the shaft is not correctly ali- gned. Withdraw it completely and screw it in again correctly.

Do not use the blender shaft:

-In a saucepan on the gas ring or hotplate.

-Empty or with ice cubes, to chop raw meat or dried fruit (almonds, hazelnuts, etc.)

13