CONNECTING THE CABLE AND STARTING YOUR APPLIANCE | EN | |
• Unravel the cable completely, connect your appliance, - fig.6 and press the On/off pedal. (2) - fig. 7. | ||
|
•Adjust the power of the vacuum : with the mechanical power adjustment : open the slider control to manually re- duce the suction power, except on fragile surfaces - fig. 8.
STORING AND TRANSPORTING THE APPLIANCE
•After use, stop the vacuum cleaner by pressing on the On/off pedal (2) and disconnect it. fig. 9. Store the cable by pressing on the pedal of the cable winder. (3) - fig. 10.
•In the vertical position, place the all floor nozzle (21) in its storage position under the appliance (1b) - fig. 11.
•In the horizontal position, place the all floor nozzle (21) in its storage position behind the appliance. (1a)- fig. 12.
•You can transport the appliance easily, thanks to its carrying handle (6).
5. CLEANING AND MAINTENANCE
Important : Always switch off and disconnect your vacuum cleaner before maintenance or cleaning.
CHANGING THE BAG
•The “bag full” indicator (4) tells you that the bag needs to be emptied or is saturated. If you notice a decrease in the efficiency of your appliance adjust the power to maximum and keep the suction nozzle lifted off the floor. If the indica- tor stays red, replace the bag.
•Take the flexible tube (17) out of the vacuum outlet. (9)- fig. 2.
•Open the cover (8) of your vacuum cleaner- fig. 13.
a) If your vacuum cleaner is equipped with a paper bag :
•Remove the bag support (14) from the bag compartment (7)- fig.14, then lift the paper bag (16a) from its support (14) by sliding on the rails (14) fig.15.
•Throw the bag in the bin. fig. 16.
•Position a new bag (14) on the bag support fig.17, then, with the help of the rails on the bag support (15) place it in the bag compartment- fig.18.
•Make sure the bag is properly positioned before closing the cover. (8).
b) If your vacuum cleaner is equipped with a textile bag* :
•Remove the bag support (14) from the bag compartment (7)- fig.19, then lift the textile bag (16b) away from its sup- port (14) by sliding it along the rails fig.20.
•Open the bag with the zip- fig. 21, then empty it in the bottom of a bin- fig. 22.
•Clean the bag with clear water- fig. 23.
•Leave to dry at least 24 hours (Do not replace the bag until it is completely dry) - fig. 24.
•Ensure that the zip is properly closed
CHANGING THE MICRO FILTER* (ref : RS-RT 3515)
Important : Change the microfilter * every 6 months.
•Open the lid (8) of your vacuum cleaner
•Open the grill protecting the motor. (11)- fig. 26.
•Pull out the micro filter*
•Put the micro filter* (12) in the bin
•Place the pins in the notches- fig. 29.
•Adjust the micro filter* behind the motor protection grill (11)
•Make sure the micro filter* is properly positioned (12) before closing the cover. (8).
CLEANING THE HEPA* FILTER CASSETTE (ref. XC0005 01)
Clean the HEPA* filter cassette every 6 months (according to frequency of use).
* According to model: this is either equipment specific to certain models or available as an optional accessory