Manuals / Tektronix / Computer Equipment / Printer

Tektronix 200E, 200I instruction sheet Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨

Models: 200E 200I

1 8

Page 7

Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ 240

4.Connect the I/O boardÕs ribbon cable to the image processor boardÕs I/O connector. Tilt the I/O board forward into place against the rear of the printerÕs card cage. Secure the I/O board in place with the two thumbscrews.

Install

I/O board

Install ribbon cable

31865-06

5.Reconnect the interface cables. Turn on the printer and examine the startup page it should automatically print out. Refer to the Phaser 240 Color Printer User Manual for details on connecting interface cables and making prints.

Page 7

Image 7

Tektronix 200E, 200I Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨, Install I/O board Install ribbon cable

Contents

Instruction Sheet Kit contentsStatic electricity precautions Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨Removing the old boards Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨processor board Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨Remove screws Lift out image31865-02 9. Lift out the engine control boardCard cage Disconnect harnesses Lift out engine boardUpgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ SIMM installation on the new image processor board1. Slide the new image processor board into its card cage slot New image processor installUpgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ 3. Reinstall the printer coversInstall I/O board Install ribbon cable Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ Return the old boards to Tektronix

Install￿

Install