
2-42
Section 2— Startup and Configuration
DPM ConfigurationsDigital Picture Manipulators (DPMs) are external video devices
connected to the switcher. In this discussion, reference is also
made to DPM levels, which are E-MEM levels into which DPM-
associated information is learned. The combined system
capabilities of the switcher and DPMs depend on:
■The video connection
■The capabilities of the DPM
■The control connection
It is not necessary to have a control connection from the switcher
to a DPM; however, the highest level of system integration is
achieved where there is a control connection.
The Video Connection (Aux Buses and Return Inputs)
A normal video signal path consists of an aux bus output from the
switcher feeding a DPM input and the DPM output returned to a
switcher input which is mapped to a switcher source select
button.
The video path through a DPM introduces a video delay into the
system. For example, Kaleidoscope introduces a 2-field video
delay.
NOTE:
If the video delay is not set correctly, there will be a glitch in the
video upon entering Effects Send mode.
There are four steps in configuring the video path:
■Aux buses are assigned to DPMs using the DPM Map Aux
Buses Menu
■Return input connections are configured using the DPM Map
Inputs Menu
■The mapping of a return connection to a crosspoint is done
using the Configuration/Map Inputs Menu
■The video delay is set using the DPM Setup Menu