4681FXI Ð Upgrading a Phaser 220e to a Phaser 220i
8.If installed, remove the RAM SIMM installed in J6 of the 220e image processor board.
9.If you removed a RAM SIMM from the 220e image processor board in Step 8, insert it in the 220i image processor board's connector J6 (or in J7 if J6 is already Þlled) (a), and tilt the module upright until it locks in place (b).
When properly inserted, a tab on each end of the connector slips into a hole on each end of the RAM SIMM. Also, a pawl on each end of the connector latches around each end of the RAM SIMM to lock it in place.
10.Repeat Step 9 to install an additional memory module in J7 if a second SIMM is available.
|
| RAM |
|
| SIMMs |
|
| a |
a | b | b |
| ||
|
| J6 |
|
| J7 |
|
|
11.Install the 220i image processor board in the card cage. Close and secure the card cage top.
12.Install the Phaser 220i's I/O board. Be sure to plug in its two I/O cables to the image processor board.
13.After you install this upgrade kit, be sure to afÞx the
14.Close and secure the card cage top. Reinstall the rear cabinet panels.
15.Reconnect the host interface cables. Turn on the printer and make a print.
4
