Helpful Hints
P6249 4 GHz 5X Active Probe Instruction Manual 25
Probe Tip Test Points
You can solder the push-in probe tip or a 0.025 square pin to a
circuit, to be used as a temporary test point. See Figure 7.
Solder the tip onto a lead or pin with a low-power soldering iron.
Press the probe head onto the tip to make a measurement, and then
pull the probe head off when you are done.
The probe tip may be removed and reused by desoldering it from the
circuit, and soldering it into another circuit in the future.
Solder
Figure 7: Using a probe tip as a test point
NOTE. Do not use pieces of solid-core copper wire be used as test
points. If the wire breaks off in the probe tip socket, it may be
impossible to remove the wire, and it will prevent insertion of other
accessory tips.