EDIT Menu

Waveform Editor

Use the waveform editor to create or edit waveform files with the extension of

.WFM. Waveform files contain waveform data, marker signal data, and the waveform output parameters set with the SETUP menu. The waveform data display formats are graphic, table, and timing. The editing functions displayed depend on the data display format.

In the waveform editor, 0 to 4094 in 12-bit resolution on the vertical axis is expressed as ±1.0000 to +1.0000 (with 4095 as 1.0005). At this level, there is no relationship to the Amplitude/Offset setting in the SETUP menu used when the waveform is output.

Entering the Waveform 1. Press EDIT in the MENU column. The initial EDIT menu will appear. Editor

2.Select Edit or New Waveform from the side menu.

Edit

Use this command to select and edit an existing

 

waveform file (.WFM)

New Waveform

Use this command to create a new waveform file

As a result of the procedure described above, the waveform editor will appear on the screen. The waveform editor can be displayed in one of three formats: graphic, timing or table; the default setting is graphic display. Figure 3 -7 shows an example in which an existing waveform file has been selected.

3 ￿14

AWG2021 User Manual