EDIT Menu

2.Select Waveform2 from the side menu.

3.Select Setting from the bottom menu.

4.Select More 1 of 2 from the side menu and then select Cursor Link to....

5.Select Waveform1 from the sub-menu. 1z will appear at the top of editing area 2.

6.Select Go Back from the sub-menu. The Setting side menu will reappear.

7.Select Select/Open from the bottom menu.

8.Select Waveform1 from the side menu.

9.Press the front panel CURSOR button.

10.Using the general purpose knob, move the active vertical bar cursor in editing area 1 and check to make sure that the vertical bar cursor in editing area 2 moves to the same degree.

In the following procedure, you will unlink the editing areas that you linked in the previous example while the waveform in editing area 1 is being edited.

1.Select Select/Open from the bottom menu.

2.Select Waveform2 from the side menu.

3.Select Setting from the bottom menu.

4.Select More 1 of 2 from the side menu and then select Cursor Link to....

5.Select Link Off from the sub-menu. The link will be canceled and the 1z at the top of editing area 2 will disappear.

Displaying a Grid in the Editing Area. This item is used to display a grid in the editing area to make it easier to edit the waveform. The following diagram shows the menu configuration.

Off

Setting ￿More 2 of 2￿

 

Grid

 

On

Figure 3 -19 shows an example of an editing area with the grid set to On.

AWG2021 User Manual

3 ￿35