EDIT Menu

Use the CURSOR button on the front panel to select the items needed for the shift register. The following items can be selected; the general purpose knob is used to set the desired value for each item.

Register Length

(sets the length of the register)

Register Position

(sets the position of the cursor)

Point/Step

(sets the number of points per step)

Code

(used to select the data code)

Setting the Register Length. The register length may be set to any value between 2 and 32. The register length is displayed at the top of the shift register configuration menu, as shown below. In this example, the shift register is made up of 32 items.

Entering the Register Value and Setting Taps. To enter the register value and set taps, press the CURSOR button on the front panel and select Register Position. A knob icon will be displayed to the left of the Register Position area. Turn the general purpose knob to move the cursor. The current location of the cursor is shown beside the Register Position item.

Taps

Figure 3 ￿90: Register Values and Taps

The numeric keys can now be used to enter the register value at the position of the cursor.

Press 0 to set the register value to 0

Press 1 to set the register value to 1

Pressing the VALUE button on the front panel toggles the tap between on and off.

￿Clearing All Taps. Use Clear All Taps in the sub-menu to delete all taps that have been set.

￿Setting the Maximum Length Code Series for Taps. Set Maximal Linear Taps in the sub-menu allows you to easily create M series (maximum length

AWG2021 User Manual

3 ￿125