Telect DNI-1B 5

Issue A Rev 2 108891 Telect, Inc.

5-1

5Service

OWNER MAINTENANCE

Telect’s DNI-1B does not need preventive maintenance.

IN CASE OF DIFFICULTY

If problems occur after initial installation, check all cable connections and

the installation instructions in Section 2.

IN-WARRANTY SERVICE

Contact your Telect equipment distributor, or call a Telect Customer Ser-

vice Representative:

1-800-551-4567

1-509-926-6000

Telect will repair or replace defective products within the limits of the war-

ranty. See “Repacking for Shipment” in this section.

NOTE

Call a Customer Service Representative for a Return Material Authoriza-

tion (RMA) before returning any equipment.

Contents

Main CONNECTING THE FUTURE DIGITAL NETWORK INTERFACE-1B USER MANUAL 108891 Issue A Rev 2 ii 108891 Issue A Rev 2 Page Contents Page 1-1 1 DNI-1B Capabilities Descriptions DNI-1B User Manual 1-2 SYSTEM-LEVEL APPLICATIONS MAIN ASSEMBLIES DNI-1B DNI-1B User Manual Descriptions PHYSICAL SPECIFICATION 1-3 Issue A Rev 2 108891 Telect, Inc. TerminationPoint Tie-DownBar Page 2-1 2 I NSTALLATION C Location and Space Installation DNI-1B User Manual 2-2 DCS Terminations Panels Total Cables Cable Space Needed per Side of Bay (in.2)EIA Bay Spaces Required 128 112 2-3 Network Bay Extender Panel I 2-4 I NSTALLATION P Mounting the DNI-1B Cabling Procedure 2-5 Page Issue A Rev 2 108891 Telect, Inc. 3-1 3 Allinternal co n- nectionsare wired, notjust chassis groundand the terminationpoints. DCSOut to NE In RemainingCircuits Are Similarly Wired Electrical Operation DNI-1B User Manual 3-2 Inserting a Bantam plug into the jack does the following: 4-1 4 P 4-2 L M D ROP -A ND -I NSERT T Page 5 O WNER M I N C ASE OF D IN-WARRANTY SERVICE OUT-OF-WARRANTY SERVICE REPACKING FOR SHIPMENT