Locate the HANDSET VOLUME key below the keypad. Press the key once and the volume level will increase one level (to MEDIUM volume). Press the key once more and the volume level will increase an additional level (to HIGH volume). To return the handset volume to NORMAL , press the handset volume key again.
The handset volume will always return to NORMAL when the handset is replaced in the cradle.
FLASH KEY
Pressing the FLASH key initiates a 600ms hookflash. Typical usage is to access PBX features like call waiting.
AUTO DIAL KEYS
The Opal has programmable AUTO DIAL keys. These keys can be programmed to automatically dial telephone numbers, or activate telephone system features.
PROGRAMMING AUTO DIAL KEYS:
The telephone must be connected to a telephone line.
1.Lift the handset from the cradle.
2.Press the recessed STORE key and release it. (Please see diagram on the next page).
3.Enter the telephone number including PAUSE* as required. The sequence can be up to 15 digits.
4.Press the AUTO DIAL key where the number is to be stored.
5.Place the handset back in the cradle.
*A 3.6 second pause is entered in a dialing sequence by pressing the REDIAL key for each PAUSE required.
CONVERTING FROM DESK TO WALL MOUNT
The Opal Telephone can be changed for wall mounting applications. The conversion is easiest when the handset and line cords are not connected.
1.Located on the top of the telephone above the speaker grill is the wall/desk mount clip. Remove this clip by firmly pushing upward (towards the hookswitch).
2.Flip the clip over (top to bottom) so that the protruding edge is towards the top of the phone. This edge will hold the handset.
3.Turn the Opal over so the bottom is up facing you. Place the Opal on a nonabrasive surface to prevent scratch- ing.
4.Locate and remove the mounting bracket, firmly push back and pull up to remove two of the four retaining tabs.
5.Rotate the mounting bracket 180 degrees clockwise so that the mounting eyelet on the bracket is facing in the same direction as the other mounting eyelet located on the bottom of the telephone.
6.Insert the top two retaining tabs of the mounting brackets into the mounting bracket slots (located near the middle of the telephone). Then firmly push down to insert the retaining tabs on the opposite side of the mounting bracket.
7.Connect a short modular line cord into the jack on the back of the phone (labeled LINE). Route the line cord thought the line cord channel. Connect the other end of line cord to the phone jack on the wall mounting plate.
8.Turn the telephone over, and slide the Opal down onto the mounting posts in downward direction. Both eyelets should line up with the mounting posts.
9.Complete the wall mounting by installing the handset and handset cord.
