Teledyne 200AU-NOy 1.0 Getting Started

Model 200AU-NOy Option Manual Addendum

1.0 Getting Started

The M501Y has been designed to operate with the M200AU low level NOx analyzer. The M200AU

manual, part number 02293, is a required reference to properly set up and operate this system.

1. The M200AU with NOy Option comes in three boxes.

• The M200AU analyzer

• The Bypass Pump Chassis

• The External Converter and umbilical cable assembly

2. Verify that there is no apparent shipping damage. If damage has occurred please advise shipper

first, then API.

CAUTION

To avoid personal injury, always use two persons to lift and

carry the Model 501 Pump Pack Chassis.

3. Before operation of the M200AU, remove the shipping screws as shown in the M200AU Manual.

4. Please check the voltage and frequency label on the rear panel of the instrument for compatibility

with the local power before plugging in the M501Y.

1. Mount the converter on a suitable mast outside of the enclosure.

2. Route the umbilical cable assembly into the shelter.

3. Locate the M200AU and M501Y Bypass Pump Chassis in close proximity, preferably mounting

one over the other in a 19” rack.

4. Connect the electrical/pneumatic cable fittings to the rear of the Bypass Pump Chassis. Use the

tags on each tube and Figure 1.1 to match up the correct tube with the rear panel bulkhead fitting.

5. Connect the 7-pin power and signal cable to the connector on the rear of the Bypass Pump Chassis.

6. Connect the power cord to the correct line voltage.

02808 Rev. E Page 7