Teledyne 200EH/EM

Operating Instructions Teledyne API - Model 200EH/EM Operation Manual

Besides SAMPLE and SETUP, other modes the analyzer can be operated in are:

Table 6-1: Analyzer Operating modes

MODE EXPLANATION

SAMPLE Sampling normally, flashing text indicates adaptive filter is on.

M-P CAL This is the basic calibration mode of the instrument and is activated

by pressing the CAL key.

SETUP X.#2 SETUP mode is being used to configure the analyzer. The gas

measurement will continue during this process.

SAMPLE A Indicates that unit is in SAMPLE mode and AUTOCAL feature is

activated.

ZERO CAL M1 Unit is performing ZERO calibration procedure initiated manually by

the user.

ZERO CAL A1 Unit is performing ZERO calibration procedure initiated automatically

by the AUTOCAL feature.

ZERO CAL R1 Unit is performing ZERO calibration procedure initiated remotely

through the COM ports or digital control inputs.

LO CAL A Unit is performing LOW SPAN (midpoint) calibration initiated

automatically by the analyzer’s AUTOCAL feature.

LO CAL R Unit is performing LOW SPAN (midpoint) calibration initiated remotely

through the COM ports or digital control inputs.

SPAN CAL M1 Unit is performing SPAN calibration initiated manually by the user.

SPAN CAL A1 Unit is performing SPAN calibration initiated automatically by the

analyzer’s AUTOCAL feature.

SPAN CAL R1 Unit is performing SPAN calibration initiated remotely through the

COM ports or digital control inputs.

DIAG One of the analyzer’s diagnostic modes is active (Section 6.13).

1 Only Appears on units with Z/S valve or IZS options.

2 The revision of the analyzer firmware is displayed following the word SETUP, e.g., SETUP

F.0.

The third operating mode is the CAL mode, which allows calibration of the analyzer in various ways. Because of

its importance, this mode is described separately in Chapter 7.

04521C (DCN5731)