Teledyne T200H/M

Teledyne API - Model T200H/T200M Operation Manual Introduction, Features, and Options

Option Option

Number Description/Notes Reference

Communication Cables For remote serial, network and Internet communication with the analyzer.

Type Description

60A RS-232

Shielded, straight-through DB-9F to DB-25M cable, about

1.8 m long. Used to interface with older computers or

code activated switches with DB-25 serial connectors.

Section 3.4.8

60B RS-232

Shielded, straight-through DB-9F to DB-9F cable of about

1.8 m length. Section 3.4.8

60C Ethernet

Patch cable, 2 meters long, used for Internet and LAN

communications. Section 3.4.8

60D USB

Cable for direct connection between instrument (rear

panel USB port) and personal computer. Section 3.4.8

USB Port For remote connection

64A

For connection to personal computer. (Separate option only when

Option 64B, Analog Input and USB Com Port not elected).

Sections 3.4.8.2

and 4.11.8

Concentration Alarm Relays Issues warning when gas concentration exceeds limits set by user.

Four (4) “dry contact” relays on the rear panel of the instrument. This

relay option is different from and in addition to the “Contact Closures”

that come standard on all TAPI instruments.

Section 3.4.7

RS-232 Multidrop Enables communications between host computer and up to eight analyzers.

Multidrop card seated on the analyzer’s CPU card.

Each instrument in the multidrop network requres this card and a

communications cable (Option 60B).

Sections 3.4.8.3

and 4.11.9

Other Gas Options Second gas sensor and gas conditioners

65A Oxygen (O2) Sensor

Figure 3-23, Figure

3-24 and Sections

3.7.2 and 8.4

86A

Sample Gas Conditioner (Dryer/NH3 Removal) for sample gas

stream only. Converts analyzer to dual-conditioner instrument. (contact Sales)

Sample Oxygenator for proper operation of the NO2-to-NO catalytic

converter. Injects oxygen into sample gas that is depleted of oxygen. (contact Sales)

Special Features Built in features, software activated

N/A

Maintenance Mode Switch, located inside the instrument, places

the analyzer in maintenance mode where it can continue sampling,

yet ignore calibration, diagnostic, and reset instrument commands.

This feature is of particular use for instruments connected to

Multidrop or Hessen protocol networks.

Call Customer Service for activation.

N/A

Second Language Switch activates an alternate set of display

messages in a language other than the instrument’s default

language.

Call Customer Service for a specially programmed Disk on Module containing

the second language.

N/A

Dilution Ratio Option allows the user to compensate for diluted

sample gas, such as in continuous emission monitoring (CEM) where

the quality of gas in a smoke stack is being tested and the sampling

method used to remove the gas from the stack dilutes the gas.

Call Customer Service for activation.

Section 4.8.2

07270B DCN6512