Teledyne T200H/M

3.6. INITIAL OPERATION

CAUTION!

If the presence of ozone is detected at any time, call Teledyne API Technical Support as soon

as possible:

800-324-5190 or email: sda_techsupport@teledyne.com

If you are unfamiliar with the theory of operation of the T200H/M analyzer, we

recommend that you read Section 8 before proceeding. For information on navigating

the analyzer’s software menus, see the menu trees described in Appendix A.

3.6.1. STARTUP

After the electrical and pneumatic connections are made, an initial functional check is in

order. Turn on the instrument. The pump and exhaust fan should start immediately. The

display will briefly show a logo splash screen at the start of initialization.

The analyzer should automatically switch to Sample Mode after completing the boot-up

sequence and start monitoring NOX, NO, NO2 gases. Allow a one-hour warm-up period.

During the warm-up period, the front panel display may show messages in the

Parameters field, such as WARNING messages.

3.6.2. WARNING MESSAGES

During warm-up, internal temperatures and other parameters may be outside of specified

limits. The software will suppress most warning conditions for 30 minutes after power

up.

SAMPLE HVPS WARNING NOX = 0.0

TEST CAL MSG CLR SETUP

Press CLR to clear the current

message.

If more than one warning is active, the

next message will take its place

Once the last warning has been

cleared, the analyzer returns to

SAMPLE mode

SAMPLE RANGE=200.0 PPM NO = 0.0

< TST TST > CAL MSG CLR SETUP

SAMPLE HVPS WARNING NOX = 0.0

TEST CAL MSG CLR SETUP

TEST deactivates warning

messages

MSG activates warning

messages.

<TST TST> keys replaced with

TEST key

NOTE:

If the warning message persists after several attempts to

clear it, the message may indicate a real problem and not

an artifact of the warm-u

eriod

Section 4.2.2 provides a table of warning messages with their definitions and the steps to

view and clear them. If warning messages persist after 30 minutes, investigate their

cause using the troubleshooting guidelines in Section 7.

07270B DCN6512