Teledyne T200H/M

Getting Started Teledyne API - Model T200H/T200M Operation Manual

STEP 3 – Set NOx and NO span gas concentrations :

Set the expected NO and NOx span gas concentration. These should be 80% of range of

concentration values likely to be encountered in this application. The default factory

setting is 100 ppm. If one of the configurable analog outputs is to be set to transmit

concentration values, use 80% of the reporting range set for that output (see Section

4.13.4)

If you supply NO span gas to the analyzer as well as NOx, the values for expected NO

and NOx span gas concentrations need to be identical.

SAMPLE GAS TO CAL:NOX

NOX O2 ENTREXIT

SAMPLE A1:NXCNC1=100PPM NOX=XXX.X

< TST TST > CAL SETUP

M-P CAL A1:NXCNC1 =100PPM NOX=X.XXX

<TST TST> ZERO SPAN CONC EXIT

SAMPLE RANGE TO CAL:LOW

LOW HIGH ENTREXIT

M-P CAL CONCENTRATION MENU

NOX NO CONV EXIT

M-P CAL NOX SPAN CONC:80.0 Conc

0 0 8 0 .0 ENTREXIT

The NOX & NO span concentration

values automatically default to

80.0 Conc.

If this is not the the concentration of

the span gas being used, toggle

these buttons to set the correct

concentration of the NOX and NO

calibration gases.

EXIT ignores the new

setting and returns to

the previous display.

ENTR accepts the new

setting and returns to

the

CONCENTRATION

MENU.

If using NO span gas

in addition to NOX

repeat last step.

07270B DCN6512