Install the water inlet hose

Before Using

Confirm the water faucet

 

Water faucet, suitable

Water faucet, not suitable

 

 

 

 

 

 

 

 

Outlet end surface

 

 

 

 

 

 

>10mm

It is required that the front end shall be longer than 10cm.

The outlet end surface of the faucet shall be flat and smooth. If not please file it to avoid leakage.

Connection between the water inlet hose jointer and the water faucet

1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1.

2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. See to the figure.)

Water inlet pipe jointer

Slider

Screw

Locking lever

Screwdriver

Mark label

Liner

Water inlet pipe

Figure 1

Figure 2

Figure 3

3.Fasten the four screws evenly. See to Figure 4.

4.Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the outlet end surface of the faucet. See to Figure 5.

Remarks: Before installation, the threading is 4mm above the upper surface of the nut. After installation, the threading is 2mm above the upper surface of the nut. See to Figure 6.

About 4mm before twisting

About below 2mm after twisting

Nut

Figure 4

Figure 5

Figure 6

61

Page 8
Image 8
Telefunken TTL-700 manual Before Using