Configuring the Modem
Configuring the Modem
You configure the modem using the three sets of DIP switches on the bottom of the modem.
,
IMPORTANT
It is important to follow the three steps described below, in the order shown, to ensure that you configure your modem properly using the modem DIP switches:
1.Use DIP switch 3 (SW3) to configure the modem for your host DTE interface and network topology. Using SW3, you select the modem to operate in
2.If you set SW3 for FSK mode in step 1, use DIP switch 2 (SW2) to configure the modem for either Bell 202T or
3.Use DIP switch 1 (SW1) to select the modem’s transmitter output level and receiver dynamic range. The SW1 settings apply for both
Page 13
