GE863-PRO3 Hardware User Guide
1vv0300773a Rev. 0 - 24/01/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 28 of 64
• The desired nominal output for the power supply is 3.8V and the maximum voltage allowed is
4.2V, hence a single 3.7V Li-Ion cell battery type is suited for supplying the power to the Telit
GE863-PRO3 module.
The three cells Ni/Cd or Ni/MH 3,6 V Nom. battery types or 4V PB types MUST NOT BE USED
DIRECTLY since their maximum voltage can rise over the absolute maximum voltage for the
GE863-PRO3 and damage it.
NOTE: DON'T USE any Ni-Cd, Ni-MH, and Pb battery types directly connected with GE863-PRO3. Their use
can lead to overvoltage on the GE863-PRO3 and damage it. USE ONLY Li-Ion battery types.
• A Bypass low ESR capacitor of adequate capacity must be provided in order to cut the current
absorption peaks, a 100μF tantalum capacitor is usually suited.
• Make sure the low ESR capacitor (usually a tantalum one) is rated at least 10V.
• A protection diode should be inserted close to the power input, in order to save the GE863-PRO3
from power polarity inversion. Otherwise the battery connector should be done in a way to avoid
polarity inversions when connecting the battery.