Installation
Parts for TERK XM5 Marine Satellite Radio Antenna
Figure 4.Verify that your TERK XM5 package includes the above items.
Recommended Tools and Supplies
• Any electric drill and bits (to drill mounting holes for the mounting bracket)
• Any socket tool/wrench set (to tighten machine bolts and hex nuts)
• Any tool to help cable routing (e.g.,flat dental pick, screwdriver, etc.)
• Grommets and silicone sealer (for cable routes)
• (Optional) Antenna Extension with 1"-14 threads
• (Optional) Substitute any mounting bracket with 1"-14 threads for the supplied bracket
Installation Precautions and Tips
• When selecting an antenna location,make sure the antenna is not enclosed by any metal material.
If a metal fly bridge is to be used,the antenna must protrude at least 5 inches above the bridge’s
top edge.Consider using an antenna extension to increase the height above the boat.
• Also,at the proposed site, verify that there is at least a 20-degree clearance from any metallic
obstruction on all sides,as shown in figure 5 (on the next page).
• Prior to installation,turn off all audio systems and other electrical devices. Disconnect the (–)
negative lead from the boat’s battery.
• At the installation site,locate and make a note of all fuel lines, cables, and electrical wiring.
Use extreme caution when cutting or drilling in and around these areas.Always wear protective
eyewear when using tools.
6Installation
SAT TER
(4) Cable Tie Wraps
(1) Splitter
(1) Mounting Bracket
With Mounting Hardware
(4) Hex Bolts/Washers/Nuts
8.75"
(1) TERK XM5 Antenna
With 30'of Attached Coaxial Cable
(1) FAKRA
Case/Clip
XM5 OM 4/8/03 09:56 AM Page 6