Math Coprocessor Option
Reassembling the Computer
After you have installed the coprocessor chip, reassemble the computer as follows.
1. Insert the keyscan board into the inside front of the top unit and lower
the front of the top unit down, almost engaging it with the bottom unit.
Be sure the plastic strip covering the LEDs is in place.
2. Check all around the case to be sure no wires protrude, then press down
on the front of the top unit so that it engages with the bottom unit.
3. Holding the top and bottom units together, turn the computer upside
down and lay it on your work surface.
4. Loosely reinsert the seven screws removed during disassembly. Again
be sure no wires protrude from between the top and bottom units.
Then tighten the seven screws.
5. Install the internal battery pack as instructed in Chapter 3 of this
manual.
TravelMate 3000 WinSX Options 6-13