www.ti.com

 

Board Layout

INPUT / OUTPUT

DESCRIPTION

J11 – GND

Return for VDCDC1

J12 – VDCDC2

Output from DCDC2 switching regulator, maximum output current 1 A, default voltage setting 2.5 V.

J13 – GND

Return for VDCDC2

J14 – VLDO1

Output from the low drop out regulator VLDO1, maximun current out is 50 mA, default value 1.1 V.

J15 – GND

Return for VLDO1

J16 –VLDO2

Output from the low drop out regulator, VLDO2 maximum current out is 50 mA, default value 1.3 V.

J17 – GND

Return for VLDO2

J18 – VDCDC3

Output from the switching regulator DCDC3, maximum current is 800 mA, default value 1.55 A

J19 – GND

Return for VDCDC3

J20 – USB

USB interface connector

JP1 – DEF 1

Sets voltage for DCDC1 to 3 V or 3.3 V.

JP2 – DEF 2

Sets voltage for DCDC2 to 2.5 V or 1.8 V.

JP3 – DEF 3

Sets voltage for DCDC3 to 1.55 V or 1.3 V.

JP4 – DCDC1 ON/OFF

EN for regulator DCDC1, default setting is ON.

JP5 – DCDC2 ON/OFF

EN for regulator DCDC2, default setting is ON.

JP6 – DCDC3 ON/OFF

EN for regulator DCDC3, default setting is ON.

JP7 – LDO ON/OFF

EN for both LDO1 and LDO2 regulators, default setting is ON.

S1 – GPIO1

S1 is a normally open momentary push-button switch that, when pressed, connects VI to GPIO1.

The GPIO1 input is configured on the TPS65020 as a debounced push button that drives an

 

ON/OFF circuit with output at GPIO2.

 

S2 is a normally open momentary push-button switch that, when pressed, connects the HOT_RST

S2 – HOT_RST

input of the TPS65020 to GND generating the Hot_Reset pulse. The HOT_RST pin is externally

 

pulled up.

2.2Setup

The following steps must be followed before the EVM is operated

1.Install the TPS65020EVM Software.

2.Connect input voltages and loads to the EVM.

3.Configure all EVM jumpers to factory setting.

JP4—ON

JP1—3.3 V

JP3—1.55 V

JP2—2.5 V

JP5—ON

JP6—ON

JP7—ON

4.Connect the Molex cable between the EVM and the EV2300. Note that the Molex cable must connect to the I2C connector on the EV2300.

5.Connect the USB cable between the computer and the EVM.

6.Turn on all supplies and loads.

7.Run the TPS65020EVM software.

3Board Layout

This section provides the TPS65020EVM-110 board layout and illustrations.

SLVU138 –August 2005

TPS65020EVM-110 User's Guide

3

Page 3
Image 3
Texas Instruments TPS65020EVM-110 manual Setup, Board Layout