FTroubleshooting
This section is designed to help you solve common problems you may encounter while using your
TravelMate 2000 Computer. If you encounter a problem which is not listed here, please contact your nearest
Texas Instruments dealer.
Unit doesn't come on Low battery-Plug in AC Adaptor
when power switch is in and run unit from ac power. After
ON position. finishing operation, leave the unit
plugged in for at least 2 hours to
charge the battery.
AC Adaptor plugged into faulty
outlet--Check ac outlet by plugging
in another appliance (e.g., a lamp).
Neither of the above-Contact your
Texas Instruments dealer.
The built-in LCD screen Screen contrast control or brightness
is blank. control-Adjust the contrast control
or the brightness control on the
right of the LCD screen.
LCD/CRT switch-Check that the
LCD/CRT switch on the left side
panel is set to LCD. When set to
CRT, the built-in screen is
automatically disabled.
None of the above-Screen power
unit may be faulty. Contact your
Texas Instruments dealer.
LCD screen backlight Display unit turned off to save
doesn't light, even when power (see "The Set up Screen"
brightness control fully section in Chapter 4).-Press any
turned up. key to turn backlight on again.
Access the Set Up screen and
change the Display Timeout setting.
If the POWER indicator is orange,
the unit is in Standby mode; press
the Fn-Pause keys to turn Standby
mode off.
Troubleshooting F-1