Texas Memory Systems RamSam-210 user manual Hot Swap Components, Hot Swapping Power Supplies

Chapter 5– Hot Swap Components

One of the main features of the RamSan-210 is the ability to hot swap many of the system components. The power supplies, fans and disk drives can all be hot swapped; meaning that these components can be removed and replacement components reinserted while the system is running.

5.1Hot Swapping Power Supplies

The RamSan-210 includes two power supplies. The system only requires one functioning power supply to run. Texas Memory Systems has taken special care to enclose the RamSan-210 power supplies in a protective case in order to minimize the electrical risks for users. It is critical, however, that users follow the following steps when removing and replacing the power supplies:

Warning:

The power supply modules maintain high voltage levels during normal operation. To prevent the risk of electrical shock, remove the power cord and wait 15 seconds before removing a power supply module.

∙Disconnect the power cord from the power supply that needs to be replaced.

∙Wait 15 seconds.

∙Remove the power supply from the RamSan-210 chassis by pressing the release switch and pulling squarely on the power supply handle. DO NOT REACH

INSIDE THE PROTECTIVE ENCLOSURE AFTER REMOVING THE POWER SUPPLY.

∙Insert the replacement power supply in the RamSan-210 chassis. Make sure to insert the power supply squarely and press firmly until the power supply is fully inserted into the system.

∙The new power supply will begin to operate within a couple of seconds.

Important:

The power supply modules are linked to the batteries. If a power supply module is removed, the battery that feeds it will not provide power to the system. In other words, the batteries only work when attached to a functional power supply. Never simultaneously remove both power supplies while the system is running. The system will cease operation.

Important:

Failed power supplies should be replaced as soon as possible.

- 21 -