BAR SINKS
BS-1515
TOOLS REQUIRED
•Ruler
•Drill
•Caulk
•Saber Saw
(if counter top cutout is required)
BS-2515
TRACE COMPLETELY AROUND EDGE OF SINK
DRAW A
AT EACH CORNER
5/16″
DRILL STARTER HOLE INSIDE OF CUTOUT LINE
CUTOUT LINE
CUT INSIDE OF LINE
1. If it is necessary to cut out | 2. Measure in 5/16″ | from the | 3. Drill starter hole inside of | 4. Using a saber saw, cut | |
the counter top, invert sink | initial sink outline and draw a | cutout line. | inside of cutout line. Trial fit | ||
and position onto the counter | second | line inside | the first. |
| sink to check proper fit. |
top. Locate sink front to rear | Draw a |
|
| ||
and so that the bowl will not | corner. This second interior |
|
| ||
interfere with the cabinets | line will be your cutout line. |
|
| ||
below. Trace a pencil line |
| Check Cutout |
|
| |
around the outside edge of | Line Measurements |
|
| ||
the sink and remove the sink | Model | Width | Depth |
|
|
from the counter top. |
|
| |||
|
|
|
Measure the cutout or the
OWNER’S MANUAL
MODEL NOS.
Installation
Care and
Cleaning
CAUTION:
Read ALL instructions carefully BEFORE starting your installation. Save this manual for future reference.